老旧煤矿健康老龄化环境建设路径分析

被关闭的低效率老旧煤矿,作为很多退休煤矿职工的家庭所在地,依然担负着为其提供正常生活条件和养老功能的任务。为了营造煤炭企业退休职工适老环境,对老旧煤矿健康老龄化环境建设路径进行了探讨。在分析健康老龄化的普遍性问题后,从公共服务、卫生健康服务、认同感、原有养老模式等方面论述了老旧煤矿存在的具体问题;针对现状及问题,从理顺养老服务管理机制和合理确定具体任务目标两方面提出了对策与建议。     

Thermal reliabilities of Sn-0.5Ag-0.7Cu-0.1Al2O3/Cu solder joint

The effects of trace addition of Al₂O₃ nanoparticles (NPs) on thermal reliabilities of Sn-0.5Ag-0.7Cu/Cu solder joints were investigated. Experimental results showed that trace addition of Al₂O₃ NPs could increase the isotheraml aging (IA) and thermal cyclic (TC) lifetimes of Sn-0.5Ag-0.7Cu/Cu joint from 662 to 787 h, and from 1597 to 1824 cycles, respectively. Also, trace addition of Al₂O₃ NPs could slow down the shear force reduction of solder joint during thermal services, which was attributed to the pinning effect of Al₂O₃ NPs on hindering the growth of grains and interfacial intermetallic compounds (IMCs). Theoretically, the growth coefficients of interfacial IMCs in IA process were calculated to be decreased from 1.61×10^-10 to 0.79×10^-10 cm²/h in IA process, and from 0.92×10^-10 to 0.53×10^-10 cm²/h in TC process. This indicated that trace addition of Al₂O₃ NPs can improve both IA and TC reliabilities of Sn-0.5Ag- 0.7Cu/Cu joint, and a little more obvious in IA reliability.     

Power Generation from Coke Oven Gas Using Chemical Looping Combustion: Thermodynamic Simulation

A chemical looping combustion (CLC) combined cycle with coke oven gas as fuel and NiO/NiAl₂O₄ as an oxygen carrier is proposed. The system was simulated by Aspen Plus® and the oxygen carrier circulation ratio was calculated. The effects of key operational temperatures and different gas turbines on the system performance were investigated. Under optimized conditions, a high CO₂ capture efficiency could be achieved. To capture CO₂ thoroughly, the PG6561B gas turbine can be employed, allowing for nearly 100 % CO₂ capture efficiency.     

自然时效效应及预时效处理对7A20铝合金组织性能的影响

研究了中强度7A20铝合金的自然时效硬化效应及预时效处理对组织和性能的影响。采用光学显微镜和透射电镜表征了其微观组织结构,采用维氏硬度计和万能拉伸试验机测试了其硬度和力学性能。结果表明:固溶态7A20试验铝合金的自然时效硬化效应明显,12天后硬度由56 HV0.5提高到122 HV0.5,提高了117.86%。经120 ℃×10 min预时效处理后,自然时效硬化增量最低,相比于固溶态降低了16 HV0.5,有效抑制自然时效硬化效应;同时,预时效处理提升了烘烤硬化效应,烘烤硬化后屈服强度提升了166 MPa,抗拉强度提高了51 MPa,伸长率降低了7%。烘烤处理前,其晶内的强化主要来自于与基体共格的GP区,烘烤处理后为尺寸小于5 nm、弥散分布的η′强化相。     

时效处理对高频感应熔覆TiC/Ni复合涂层的组织及性能影响

为了改善抽油杆材料的表面性能,采用高频感应熔覆技术在其表面制备了TiC/Ni复合涂层。采用光学显微镜、扫描电镜(SEM)、能谱仪(EDS)、X射线衍射仪(XRD)等研究了涂层经固溶及不同时间时效处理后的显微组织及物相组成,并利用显微硬度计及摩擦磨损实验测试了时效后涂层的性能变化。结果表明:经固溶时效后的涂层并未出现明显缺陷,涂层主要以γ-Ni固溶体、Ni的化合物、CrB、碳化物以及δ相等硬质颗粒组成;时效后涂层的最大硬度达到928.2 HV0.2,相比时效前提高了4%,最低磨损量为48.9 mg,比基材减少了62%,在时效4 h后,涂层的综合性能最好。     

Alkyl Tail Segments Mobility as a Marker for Omega-3 Polyunsaturated Fatty Acid-Rich Linseed Oil Oxidative Aging

Omega-3 polyunsaturated fatty acid (PUFA)-rich linseed oil (LSO) is an important component in biological systems, foods, and many other industrial products. In recent years, LSO has attracted increased attention in the field of functional foods, which has highlighted its facile susceptibility to aging by autoxidation. Common colorimetric and a long list of spectral methodologies have been used to follow after and predict LSO shelf life's quality, especially in regards to aging by autoxidation. These standard methodologies are nevertheless limited, because of the complexity of the LSO's chemical and physical changes. The goal of the present study is to develop a sensorial ¹H LF-NMR energy relaxation time application based on monitoring primary chemical and structural changes occurring with time and temperature during oxidative thermal stress for better and rapid evaluation of LSO's aging process. Using ¹H low-field NMR, the different T₂ times of energy relaxations due to spin–spin coupling, and proton motion/mobility of LSO molecular segments were monitored. As previously reported, we characterized the chemical and structural changes in all phases of the autoxidation aging process. Starting from the initiation phase (abstraction of hydrogen radical, fatty acid chain rearrangement, and oxygen uptake yielding hydroperoxides products), through to the propagation phase (chain reactions resulting in tail cleavage to form alkoxy radicals, and alpha, beta-unsaturated aldehydes formation), and a termination phase (cross linking and production of polymerization end products). The ¹H LF NMR transverse relaxation approach, monitors both the covalent bond's strong forces (100–400 kJ mol⁻¹) in LSO oxidative aging decomposition, as well as secondary relatively weak interactive forces by hydrogen bonds (~70 kJ mol⁻¹), and electrostatic bonds (0–50 kJ mol⁻¹) contributing to secondary crosslinking interactions leading to a LSO viscous gel of polymerized products in the termination phase. In the present paper, we show that LSO tail segments mobility in terms of T₂ multi-exponential energy relaxation time decays, generated by data reconstruction of ¹H transverse relaxation components are providing a clear, sharp, and informative understanding of LSO sample's autoxidation aging processes. To support T₂ time domain data analysis, we used data from high-field band-selective ¹H NMR pulse excitation for quantification of hydroperoxides and aldehydes of the same LSO samples treated under the same thermal conditions (25, 40, 60, 80, 100, 120 °C) with pumped air for 168 hours. Peroxide value, viscosity, and self-diffusion analyses, as well as fatty acids profile and by-products determined by GC–MS on the same samples were carried out, and correlated with the LSO tail T₂ energy relaxation time results. From these results, it is postulated that selective determination of LSO tail T₂ time domain can be used as a rapid evaluation marker for following omega-3 PUFA-rich oils oxidative aging process within industrial and commercial products.     

Effect of vinyl acetate content on the photovoltaic-encapsulation performance of ethylene vinyl acetate under accelerated ultra-violet aging

The vinyl acetate (VA) content in ethylene vinyl acetate (EVA) can significantly affect its performance as an encapsulant in photovoltaic modules under field conditions. EVA films of varying VA content (18, 24, 33, and 40%) have been prepared using twin screw extruder with the necessary additives and subsequently cured at 150 °C. All the EVA films have been subjected to UV radiation at a wavelength of 340 nm for 1000 and 2000 h to simulate accelerated field aging. The effects of accelerated aging on the gel content, mechanical properties, transmittance, Fourier transform infra-red (FTIR) spectra, thermal stability, degree of crystallinity, and yellowness have been studied. The observations made in this study of UV aging up to 2000 h suggests that the optimum range of VA content in EVA should be between 18 and 33% by weight. VA content beyond 40% degrades almost all properties needed for an encapsulate material after aging of only 2000 h. VA content of around 18% is the most stable under UV aging conditions but has a slightly lower value of transmittance for the unaged sample although the difference in transmittance between different specimens decreases with UV aging. © 2019 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2020 , 137, 48268.     

Emergency egress for the elderly in care home fire situations

Practitioners are continuing to develop egress modelling software for the design of the built environment. These models require data about human behaviour and factors for calibration, validation and verification. This study aims to address the specific data and knowledge gap: emergency egress of the elderly. Such data are difficult to collect given privacy and consent concerns, with strong relationships generally being required between residences and researchers. Through the observation of nine fire drills at six Canadian long-term care (LTC) and retirement homes, specific evacuation actions and behaviour were observed for 37 staff members and information about the evacuation of 56 residents was collected. These drills demonstrated that emergency egress in LTC and retirement homes is highly staff dependent with 72% of residents recorded requiring full assistance at all stages of movement in evacuation, and that the type of announced/unannounced drill and level of resident care will affect the type of data collected. The development of travel speed and pre-movement is discussed subject to limitation with qualitative behavioural insights of residents that were observed. This study provides valuable methodological discussion on how to conduct behavioural studies in similar highly restricted research environments. Specific attention is given to understanding the considerations that must be made when using fire drills as data sources, and the impact that these can have on using such data for modelling. This study may inform the initial setup and programming of evacuation models from an actions and behavioural perspectives of staff members and residents.     

Influence of External Interface Normal Stress on the Growth of Cu-Sn IMC During Aging

A U-shape clamp was designed to apply stress perpendicular to the interface of Cu/Sn/Cu solder joints, and its influence on the growth behavior of Cu-Sn intermetallic compound (IMC) during thermal aging at 150 °C was investigated. The results show that compared with the sample at general stress-free state, the growth rate of IMC under compression is faster, while that under tension is slower. Moreover, the interface between IMC and Sn is smoother under compressive stress, and the corresponding IMC grains are smaller and more uniform than that under tensile stress. According to the growth kinetic analysis, the growth of IMC under general, compressive and tensile states is all controlled by the combination of grain boundary diffusion and volume diffusion with a similar growth exponent (n ≈ 0.4). However, external stress can affect the Ostwald ripening process of grain growth, causing a change of grain size and grain boundary density in the IMC layer. As a result, the IMC growth behavior at the interface of the solder joint will be affected by the applied external normal stress.